* changes:
vp9_frame_scale_ssse3.c: make 2 functions static
vp9_pickmode.c: make function static
vp9_noise_estimate.c: make function static
vp9_aq_360.c: add missing include
vp9_idct_intrin_sse2: add missing vp9_rtcd.h include
vpx_dsp/*.[hc]: add missing vpx_dsp_rtcd.h include
Makes the noise estimation react little faster.
Little/no change in metrics.
Change only affects 1 pass cbr.
Change-Id: I13f0daa90ecbf9d49eb1cf2e48febd9d92292940
Fix will reset the consec_zero_mv map on non-skipped blocks with non-zero mv.
Adjust thresholds on consec_zero_mv in noise estimation and skin detection,
as more possible reset on map means lower thresholds should be used.
Change-Id: Ibe8520057472b3609585260b51b6f95a38fb777d
So it can be used even with aq-mode=3 not enabled.
Also cleans up some code in the places where its used.
No change in behavior.
Change-Id: Ib6b265308dbd483f691200da9a0be4da4b380dbc
This make it more likely clean/low-noise content will
be set as LowLow, and hence no denoising will be done.
Also set early exit on denoising for small blocks.
Change-Id: I4a72bba3e6c5e2d523d304c39deacc9c39bf216c
Put check to avoid possible out of bounds when looping
over the blocks to estimate noise level.
No change in behavior.
Change-Id: I4b7b19b7edee0ae1c35b9dc0700b1bf9b304d7f5
Add function to compute skin map for a given block, as its
used in several places (cyclic refresh, noise estimation, and denoising).
Change-Id: Ied622908df43b6927f7fafc6c019d1867f2a24eb
This is so we may update level at any time (e.g., to be used
for setting thresholds in variance-based partition).
Change-Id: I32caad2271b8e03017a531f9ea456a6dbb9d49c7
Change initial state of noise level, and only update
denoiser with noise level when estimate is done.
Change-Id: If44090d29949d3e4927e855d88241634cdb395dc
Add threshold/condition on spatial_variance and brightness level.
Modification to normalization of block variance.
Change resolution limit below which we disable noise estimation.
Change-Id: If5be08a26ceda351242d8a58d2f0bc88c0a918f0
Source noise level estimate is also useful for
setting variance encoder parameters (variance thresholds,
qp-delta, mode selection, etc), so allow it to be used also
if denoising is not on.
Change-Id: I4fe23d47607b4e17a35287057f489c29114beed1
