This flag was added to VP8 to allow a mode where MB-level skipping
was not allowed, saving a bit per mb. It was never used in practice,
and hasn't been tested in VP9, so remove it.
Change-Id: Id450ec6904c6d06c1919508e7efc52d05cde5631
tx_type == DCT_DCT check is an implementation detail of iht_add. Also
adding dequant_add_y function with explicit DCT_DCT check inside.
Change-Id: Ia3cb0225601752cdef0ff6f0acd3a09d9dbd8938
In decoder, the scaling calculation, such as (mv * x_num / x_den),
is fairly time-consuming. In this patch, we check if the scaling
happens or not at frame level, and then decide which function to
call to skip scaling calculation when no scaling is needed. Tests
showed a 3% decoder performance gain.
Change-Id: I270901dd0331048e50368cfd51ce273dd82b8733
This is the first CL with vp9_reader changes. All another macro
definitions will be replaced after.
Change-Id: I1c6bd9c9a612ec1663d484d6adb4fb720af54063
Static threshold results slightly up (+0.1% on derf), probably b/c
we now take the filter (sharp/lowpass) into account for the breakout
decision.
Change-Id: I9f597601da434205142afd05f32690e7ba8fd690
This is work-in-progress, it implements multiple ARF
encoding behind an experimental flag.
It adds the ability to insert multiple ARF frames into a
single ARF group. This patch implements the reordering
of the coded frames, and implements a fixed-length coding
pattern. It applies a fixed quantizer strategy based on
where the frame is in the coding sequence.
Further work to modify the rate control strategy is
ongoing and will be submitted via a set of future patches.
In this first step, each ARF group is recursively
bisected and an ARF frame added at that position in the
sequence. The recursion continues until ARF frames are
within MIN_GF_INTERVAL frames.
The code sits behind the "multiple-arf" experimental
flag ("CONFIG_MULTIPLE_ARF"). The experimental flag
"oneshotq" ("CONFIG_ONESHOTQ") also needs to be enabled
for this patch to work correctly.
Change-Id: Ie473b05ebb43ac473c0cfb659b2b8042823085e2
Combine superblock inter predictors into a unified function that
allows configurable block width and height. The inter predictions
of block sizes smaller than 16x16 are handled differently. To be
continued on merging them later.
Change-Id: I14075959dd5e221f00c205c99ca35c1c31ef728e
To match the order of directional intra prediction modes for larger
blocks, also renamed the i4x4 prediction modes to mirror the larger
variants.
Change-Id: I77cea4d0add6c7758460bf9c7a2fe59aca601f0b
The probabilities derived from these statistics are used in bitstream
writing; therefore, we should only do this when we actually decide to
use macroblock coding (over superblock coding). Derf gains +0.15%.
Change-Id: I196814c070a7c79889590658ce10a6eb07454389
The intra predictor supports configurable block sizes. It can handle
intra prediction down to 4x4 sizes, when enabled in BLOCK_SIZE_TYPE.
Change-Id: I7399ec2512393aa98aadda9813ca0c83e19af854
Rename pick_mb_modes to pick_mb_mode, since it now handles only a
single macroblock. This is consistent with pick_sb_mode handling a
single non-macroblock.
Change-Id: I896fdfa06436b2d8c24d6474718cc74420df6b3b
