libssh2 - SSH2 library
======================
libssh2 is a library implementing the SSH2 protocol, available under
the revised BSD license.
Generic installation instructions are in INSTALL. Some ./configure
options deserve additional comments:
* --enable-crypt-none
The SSH2 Transport allows for unencrypted data
transmission using the "none" cipher. Because this is
such a huge security hole, it is typically disabled on
SSH2 implementations and is diabled in libssh2 by
default as well.
Enabling this option will allow for "none" as a
negotiable method, however it still requires that the
method be advertized by the remote end and that no
more-prefferable methods are available.
* --enable-mac-none
The SSH2 Transport also allows implementations to
forego a message authentication code. While this is
less of a security risk than using a "none" cipher, it
is still not recommended as disabling MAC hashes
removes a layer of security.
Enabling this option will allow for "none" as a
negotiable method, however it still requires that the
method be advertized by the remote end and that no
more-prefferable methods are available.
* --disable-gex-new
The diffie-hellman-group-exchange-sha1 (dh-gex) key
exchange method originally defined an exchange
negotiation using packet type 30 to request a
generation pair based on a single target value. Later
refinement of dh-gex provided for range and target
values. By default libssh2 will use the newer range
method.
If you experience trouble connecting to an old SSH
server using dh-gex, try this option to fallback on
the older more reliable method.
* --with-libgcrypt
* --with-libgcrypt-prefix=DIR
libssh2 can use the Libgcrypt library
(http://www.gnupg.org/) for cryptographic operations.
Configure will attempt to locate Libgcrypt in the
default location, but if you have installed it
somewhere else, use the --with-libgrypt-prefic=DIR
parameter.
* --with-openssl=[DIR]
libssh2 can use the OpenSSL library
(http://www.openssl.org) for cryptographic operations.
Configure will attempt to locate OpenSSL in a number
of default locations:
/usr/local/ssl
/usr/local
/usr
/usr/local/openssl
If your installation of OpenSSL is in another
location, specify it here.
* --with-libz=[DIR]
If present, libssh2 will attempt to use the zlib (http://www.zlib.org)
for payload compression, however zlib is not required.
Configure will attempt to location a zlib installation
in a number of default locations:
/usr/local
/usr
/usr/local/libz
/usr/libz
/usr/local/zlib
/usr/zlib
If your installation of zlib is in another location,
you may specify it here.
