Some parameter changes and fixes on one-pass rate control.
derfraw300 is now only 10% below 2-pass speed 0 rate control.
Change-Id: I1940eef8a5a035dc18e71b880d5e00cabd1f01b9
Inlcudes a number cleanups:
1. Moves the one-pass pre-encode parameter setting functions
to vp9_ratectrl.c
2. Deprecates per_frame_bandwidth in RATE_CONTROL structure
3. Removes target_bandwidth in cpi structure since it is not used.
4. Various renaming of functions
There is no bit-stream change in 2-pass, one-pass cbr and one-pass
vbr modes.
Change-Id: Ifd9916bf4d485b7d04c5f52044ffe6703254ccbd
Fixes rate control partially in one-pass non-cbr case to achieve a
bitrate close to the one desired. Previous version was way off at
the high bitrate end.
Also includes several one-pass rate control cleanups and refactoring.
On derfraw300, one-pass encoding is now 19% off from two-pass speed
0 encoding, down from 35%.
Change-Id: I6f0dcdb7f8aa85a7e7cd3a3155d4f9d2a4d2f4f4
Added a constant to represent the minimum KF boost
rather than using the magic number 2000 in the code.
Change-Id: I9428b61f47d26312caff81c6f9ae8587df004791
Includes a few fixes and clean-ups that adds the ability
to use alt-ref frames in one-pass mode.
Whether alt-refs are actually used or not is controlled by a
macro USE_ALTREF_FOR_ONE_PASS in vp9_firstpass.c.
This first cut seems to improve derf by 15+% in 1-pass mode.
But further experiments with parameters are underway.
Change-Id: I78254421435478003367c788c7930d2dc4ee2816
The sum of squared mv components can go beyond int range for large
input resolution. This commit changed the type to int64 to avoid
overflow.
Change-Id: Ib21ea2817845cea1435f893064e6417c79c5bc64
Applies an upper limit on burst bitrate for any
frame. This is to insure that typical encodes for YT
do not produce frames that are so large that they
risk stalling HW implementations. Such frames
could also cause playback problems in SW.
For now the limit is set at 250 bits per MB for 1080P
and larger (with the 1080P limit used for smaller frames).
Setting maxQ, constant quality mode or targeting a
very high bandwidth will have precedence over this limit.
Change-Id: Ie6f776c38b06ac7cec043d034085f4b79ee46a38
To reduce pulsing we now allow an arf just before forced key frames
and at the end of a clip or section (which may be stitched to
another clip or section). However, this does not make sense for
key frames arising from real scene cuts.
Change from original patch reflects other recent changes in regard
to alignment of gf/arf and kf groups.
Change-Id: I074a91d1207e9b3e28085af982f6718aa599775f
