This patch introduces the concept of dual inter16x16 prediction. A
16x16 inter-predicted macroblock can use 2 references instead of 1,
where both references use the same mvmode (new, near/est, zero). In the
case of newmv, this means that two MVs are coded instead of one. The
frame can be encoded in 3 ways: all MBs single-prediction, all MBs dual
prediction, or per-MB single/dual prediction selection ("hybrid"), in
which case a single bit is coded per-MB to indicate whether the MB uses
single or dual inter prediction.
In the future, we can (maybe?) get further gains by mixing this with
Adrian's 32x32 work, per-segment dual prediction settings, or adding
support for dual splitmv/8x8mv inter prediction.
Gain (on derf-set, CQ mode) is ~2.8% (SSIM) or ~3.6% (glb PSNR). Most
gain is at medium/high bitrates, but there's minor gains at low bitrates
also. Output was confirmed to match between encoder and decoder.
Note for optimization people: this patch introduces a 2nd version of
16x16/8x8 sixtap/bilin functions, which does an avg instead of a
store. They may want to look and make sure this is implemented to
their satisfaction so we can optimize it best in the future.
Change-ID: I59dc84b07cbb3ccf073ac0f756d03d294cb19281
This is an experiment to include a mv contribution from last frame to
nearest and near mv definition. Initial test showed some small though
consistent gain.
latest patch slightly better result ~.13%-~.18%.
TODO: the entropy used to encode the mode choice, i.e. the mv counts
based conditional distribution of modes should be re-collected to
reflect this change, it is expected that there is some further gain
from that.
Change-Id: Ief1e284a36d8aa56b49ae5b360c91419ec494fa4
This commit added a 3 bit index to the bitstream, the index is used to
look into the intra mode coding entropy context table. The commit uses
the mode stats to calculate the cost of transmitting modes using 8
possible entropy distributions, and selects the distribution that
provides the lowest cost to do the actual mode coding.
Initial test show this provides additional .2%~.3% gain over quantizer
adaptive intra mode coding. So the adaptive intra mode coding provides
a total of .5%(psnr) to .6% gain(ssim) combined for all-key-encoding
To build and test, configure with
--enable-experimental --enable-qimode
Change-Id: I7c41cd8bfb352bc1fe7c5da1848a58faea5ed74a
Only the first frame buffer ref counter was being initialized
because the index was fixed at 0 rather than using i.
Change-Id: Ib842298be4a5e3607f9e21c2cd4bfbee4054ffc4
The error-concealer is plugged in after any motion vectors have been
decoded. It tries to estimate any missing motion vectors from the
motion vectors of the previous frame. Intra blocks with missing
residual are replaced with inter blocks with estimated motion vectors.
This feature was developed in a separate sandbox
(sandbox/holmer/error-concealment).
Change-Id: I5c8917b031078d79dbafd90f6006680e84a23412
the decision to run the regular or simple loopfilter is made outside the
function and managed with pointers
stop tracking the option in two places. use filter_type exclusively
Change-Id: I39d7b5d1352885efc632c0a94aaf56b72cc2fe15
Golden and ALT reference buffers were refreshed by copying from
the new buffer. Replaced this by index manipulation.
Also moved all the reference frame updates to one function for
easier tracking.
Change-Id: Icd3e534e7e2c8c5567168d222e6a64a96aae24a1
A large number of functions were defined with external linkage, even
though they were only used from within one file. This patch changes
their linkage to static and removes the vp8_ prefix from their names,
which should make it more obvious to the reader that the function is
contained within the current translation unit. Functions that were
not referenced were removed.
These symbols were identified by:
$ nm -A libvpx.a | sort -k3 | uniq -c -f2 | grep ' [A-Z] ' \
| sort | grep '^ *1 '
Change-Id: I59609f58ab65312012c047036ae1e0634f795779
This eliminates a large set of warnings exposed by the Mozilla build
system (Use of C++ comments in ISO C90 source, commas at the end of
enum lists, a couple incomplete initializers, and signed/unsigned
comparisons).
It also eliminates many (but not all) of the warnings expose by newer
GCC versions and _FORTIFY_SOURCE (e.g., calling fread and fwrite
without checking the return values).
There are a few spurious warnings left on my system:
../vp8/encoder/encodemb.c:274:9: warning: 'sz' may be used
uninitialized in this function
gcc seems to be unable to figure out that the value shortcut doesn't
change between the two if blocks that test it here.
../vp8/encoder/onyx_if.c:5314:5: warning: comparison of unsigned
expression >= 0 is always true
../vp8/encoder/onyx_if.c:5319:5: warning: comparison of unsigned
expression >= 0 is always true
This is true, so far as it goes, but it's comparing against an enum, and the C
standard does not mandate that enums be unsigned, so the checks can't be
removed.
Change-Id: Iaf689ae3e3d0ddc5ade00faa474debe73b8d3395
Changes 'The VP8 project' to 'The WebM project', for consistency
with other webmproject.org repositories.
Fixes issue #97.
Change-Id: I37c13ed5fbdb9d334ceef71c6350e9febed9bbba
The main reason for the change was to reduce cycles in the token
decoder. (~1.5% gain for 32 bit) This layout should be more
cache friendly.
As a result of this change, the encoder had to be updated.
Change-Id: Id5e804169d8889da0378b3a519ac04dabd28c837
Note: dixie uses a similar layout
The memory being zeroed in vp8_update_mode_info_border() was just
allocated with calloc, and so the entire function is actually
redundant, but it should be made correct in case someone expects
it to actually work in the future.
Change-Id: If7a84e489157ab34ab77ec6e2fe034fb71cf8c79
At the end of the decode, frame buffers were being copied.
The frames are not updated after the copy, they are just
for reference on later frames. This change allows multiple
references to the same frame buffer instead of copying it.
Changes needed to be made to the encoder to handle this. The
encoder is still doing frame buffer copies in similar places
where pointer reference could be done.
Change-Id: I7c38be4d23979cc49b5f17241ca3a78703803e66
When the license headers were updated, they accidentally contained
trailing whitespace, so unfortunately we have to touch all the files
again.
Change-Id: I236c05fade06589e417179c0444cb39b09e4200d
This patch creates some basic infrastructure for doing bitstream-
incompatible changes to the VP8 encoder. The key parts are:
- --enable-experimental configure switch, to enable support for this
incompatible bitstream. This switch is required to be set to enable
any "experiments"
- A list for "experiments" which translate into --enable-<experiment>
options and CONFIG_<experiment> macros.
- The high bit of the "Version" field is used to indicate that the
bitstream was produced by an experimental encoder. The decoder will
fail to decode an experimental bitstream without
--enable-experimental.
- A new "vp8x" encoder interface is created to set the experimental
bit.
- The vp8x encoder interface is made the default for ivfenc in
experimental mode.
Change-Id: Idbdd5eae4cec5becf75bb4770837dcd256b2abef
This doesn't play well with autotools, and the preprocessor magic is
confusing and unhelpful in the vp8-only context.
Change-Id: I2fcb57e6eb7876ecb58509da608dc21f26077ff1
