ARF overlays now use the same rate correction factor as regular inter
frames, further testing would be needed to see if it makes sense to use
a completely separate rate correction factor for ARF overlays.
$ vpxenc --cpu-used=5 --fps=50/1 --target-bitrate=2000
parkjoy.y4m -o out.webm
=> Before: 3356 kb/s
=> After: 2271 kb/s
Change-Id: I73e4defa615ba7a8a2bdb845864f4b1721cbbffe
This commit estimates the motion vector rate cost right after full
pixel motion search. It combines this and the mode cost and compares
the corresponding rate-distortion cost. If it is already above the
current best one, skip the rest sub-pixel motion search and modeling
process. For pedestrian_area 1080p at 4000 kpbs, the speed -5 runtime
goes down from 39425 ms -> 38399 ms.
Change-Id: If4cd7119fd6c266798d5cf1d19d19ab425e52a26
Reinstates this macro and truns it on in order to avoid issues
due to some frames at the end starving in harder videos.
A more acceptable solution is in the works.
Change-Id: I3c46148e86fa6114e3fed245246fb3686a9e6700
This commit slightly increases the bit allocation for key frame. This
improves speed -5 coding performance by 2.77% with aq-mode=0 and by
2.78% with aq-mode=3.
Change-Id: Iaa3e777f80b9706306606af06e89852bac146659
For real-time mode under cbr, this increases the gain (5-10%)
for speed 5 (none/little change for 6), on vc-clips.
Change-Id: I9b38beeb3c820de22c43a0ba53a9456168dd24ba
Turns off the DISABLE_RC_LONG_TERM_MEM macro and makes other changes
in the way the bits are updated, to make 2-pass rate control track
target bitrates closer.
Change-Id: I5f3be4b11c2908e6a9a9a1dd4fcf4e65531c44d8
This commit reduces the frequency of frames using finer quantizer
in non-RD coding flow, and slightly tune up the quantizer resolution
when used. It provides 1.7% compression gains in speed -5 at no speed
difference.
Change-Id: I430249a51260a841a0402666e5ec1566e4f7d5a6
The new tolerance is a little higher than before (especially
for kf/gf/arf) so this change gives an encode speed up
for some clips up for speeds 0-2.
Change-Id: I63f7d6c9cc11c7f58742f41e250dcd3eab1741eb
This code/setting was actually not used (since speed features were not set on first frame,
until a recent change) and should be removed.
In CBR mode, the q value for the first frame can be controlled by setting
the target size via the parameters rc_buf_initial_sz (and max_intra_size_pct).
Change-Id: I65afc64972b36c449bd5a8c25800e65da5389066
