Added drop_frame support in multi-resolution encoder.
If one frame is dropped at a lower-resolution level, the next
upper-resolution level encoder needs to encode that frame
independently without any lower-resolution level motion
information.
Another issue is that if one frame is dropped at some but not all
resolution levels, a frame after that one may use different set
of reference frames at different resolution levels. This reference
frame asynchronization could degrade motion search precision in
upper-resolution level encoding, which uses lower-resolution level
motion result. This change compares the lower-resolution and upper-
resolution level's reference frames. If they are not the same, the
upper-resolution level encoder can not use lower-resolution level
motion result.
Change-Id: I61afa4f313630e75b7cbdd5742e230e8724a988a
In multi-resolution encoding, frame_type decision for each frame
is made by the lowest-resolution encoder. For all other higher-
resolution encoders, kf_mode is always set to VPX_KF_DISABLED,
and they are forced to use the same frame_type picked by the
lowest-resolution encoder.
Change-Id: Ic4d52ec65bbc012ca9c2d236210e28a295591eaf
The example encoder down-samples the input video frames a number of
times with a down-sampling factor, and then encodes and outputs
bitstreams with different resolutions.
Support arbitrary down-sampling factor, and down-sampling factor
can be different for each encoding level.
For example, the encoder can be tested as follows.
1. Configure with multi-resolution encoding enabled:
../libvpx/configure --target=x86-linux-gcc --disable-codecs
--enable-vp8 --enable-runtime_cpu_detect --enable-debug
--disable-install-docs --enable-error-concealment
--enable-multi-res-encoding
2. Run make
3. Encode:
If input video is 1280x720, run:
./vp8_multi_resolution_encoder 1280 720 input.yuv 1.ivf 2.ivf 3.ivf 1
(output: 1.ivf(1280x720); 2.ivf(640x360); 3.ivf(320x180).
The last parameter is set to 1/0 to show/not show PSNR.)
4. Decode:
./simple_decoder 1.ivf 1.yuv
./simple_decoder 2.ivf 2.yuv
./simple_decoder 3.ivf 3.yuv
5. View video:
mplayer 1.yuv -demuxer rawvideo -rawvideo w=1280:h=720 -loop 0 -fps 30
mplayer 2.yuv -demuxer rawvideo -rawvideo w=640:h=360 -loop 0 -fps 30
mplayer 3.yuv -demuxer rawvideo -rawvideo w=320:h=180 -loop 0 -fps 30
The encoding parameters can be modified in vp8_multi_resolution_encoder.c,
for example, target bitrate, frame rate...
Modified API. John helped a lot with that. Thanks!
Change-Id: I03be9a51167eddf94399f92d269599fb3f3d54f5
