Use the appropriate subblock offset mode info rather than the parent
block base, when filling mbmi in the pc tree in nonrd_use_partition.
This mimics what is done in the vertical case and what is done for
both cases in nonrd_pick_partition.
This change has little practical effect at the moment since in speed 5
rt horizontal and vertical partitions are currently only used unpaired
at edges of the picture.
Change-Id: I4632f66ca84086dac56c7d36b45ddbe38a06f42a
This did the same correction as the one in commit "Correct ssse3
8/16-pixel wide sub-pixel filter calculation" to avoid saturation
during filtering.
Change-Id: Ife9aa3f62daf9114eb24fe38f7baa3c3f361b2d6
If we are already saving a lot in bits from the target (maximum)
bitrate in the constrained quality mode, allow the quantizer
to go lower than the cq level. This hopefully will solve issues
with getting too low a bitrate and consequently poor quality for
certain videos in cq mode.
Change-Id: I1c4e8b0171fcf58f95198b3add85eea5f3c8f19f
If the denoiser filter causes too big a change in the absolute pixel difference
(between source and denoised signal), the block is not denoised, which can cause
visual block artifacts. This change applies a second adjustment to the temporal filter
to effectively allow for a (weaker) denoising for such blocks (which can keep
the absolute differnence within the tolerance range in most cases).
This helps to reduce some of the block artifacts from the denoising.
The additional cost of re-applying the filter to this set of blocks is low,
as the percentage of blocks per frame (with too big a change in absolute pixel difference)
is typically small, 2-5%.
Change-Id: Id9b56e59e33f3c22e79d2f89f763bdde246fdf3f
Renames all x86_64 specific assembly files to consistently
end in _x86_64.asm. This will be useful for build systems to
handle these files differently.
All new 64-bit specific assembly files should use the new
naming convention.
Change-Id: I36c89584967c82ffc4088b1b5044ac15d2bb7536
This commit changed to enable the encoder to adjust motion dection
speed threshold based on picture size. In addition, cpu-used 1 now
does a partition search every other frame instead of every third
frame for low resolution inputs.
The change has no quality/speed impact for 720p and above. Test
showed the change increase encoding time by between 3% to 6% for
cpu-used 2 encodiong of 360p sequences. It also has a compression
gain about .3%.
For cpu-used 2, the change resolved some very disturbing visual
artifacts in certain sequences when large block partitionings and
transforms are used as a result of copying the partition from a
previous frame.
Change-Id: Ic7fd22508cdb811d4ca935655adbf20109286cfa
The final goal is eventually to get rid of both itxm_add and fwd_txm4x4.
This patch does it in the decoder.
Change-Id: Ibb3db57efbcbb1ac387c6742538a9fcf2c6f24a5
