Change submitted for Adrian Grange. Convert threshold
calculation in ARNR filter to a lookup table.
Change-Id: I12a4bbb96b9ce6231ce2a6ecc2d295610d49e7ec
Previously we had assumed that it was necessary to give a full frame's
bit allocation to the alt ref frame if it has been created through temporal
filtering. This is not the case. The active max quantizer control
insures that sufficient bits are allocated if needed and allocating a
full frame's worth of bits creates an excessive overhead for the ARF.
Change-Id: I83c95ed7bc7ce0e53ccae6ff32db5a97f145937a
Corrected setting of "which_buffer" for U & V cases to match that
used for Y, i.e. to refer to the temporally most recent frame of
those to be filtered.
Change-Id: Idf94b287ef47a05f060da3e61134a0b616adcb6b
The new fdct lowers the round trip sum squared error for a
4x4 block ~0.12. or ~0.008/pixel. For reference, the old
matrix multiply version has average round trip error 1.46
for a 4x4 block.
Thanks to "derf" for his suggestions and references.
Change-Id: I5559d1e81d333b319404ab16b336b739f87afc79
1. Unavailability of each reference frame type should be tested
independently,
2. Also, only the VP8_GOLD_FLAG needs to be tested before setting
golden frame specific thresholds, and only VP8_ALT_FLAG needs
testing before setting thresholds relevant to the AltRef frame.
(Raised by gbvalor, in response to Issue 47)
Change-Id: I6a06fc2a6592841d85422bc1661e33349bb6c3b8
Since the intent is
to reset the appropriate bit in ref_frame_flags not to
test a logic condition. Prior result would always have
been ref_frame_flags being set to 0.
(Issue reported by dgohman, issue 47)
Change-Id: I2c12502ed74c73cf38e98c9680e0249c29e16433
When the license headers were updated, they accidentally contained
trailing whitespace, so unfortunately we have to touch all the files
again.
Change-Id: I236c05fade06589e417179c0444cb39b09e4200d
Visual c++ compiler uses xmm registers for floating point
operations for 64 bit architecture, therefore its calling
convention requires the preservation of xmm6-xmm15 in any
function that have used these registers. However, the sse2
functions, that were originally written for 32 bit windows,
may have used xmm6 and xmm7 without preserving the content.
In this particular case, the compiler used xmm6 to save
the variable "two_pass_min_rate", the value of the variable
is mucked up by our sse2 optimized loop filter functions,
hence the results of release/debug mismatching.
