This patch provides a partial rapid feedback of bits
resulting from extreme undershoot.
Some improvement on some problem animated material
but in its current form only a small impact on the metrics results
of our standard test sets.
Change-Id: Ie03036ea8123bc2553437cb8c8c9e7a9fc5dac5d
This patch addresses two issues that can occur when the
encoder chooses to use a mixture of ARF and GF groups.
The first issue relates to a failure to reset the "ARF active" flag
correctly when transitioning from coding ARF groups to coding
GF groups. This caused some golden frames to be encoded
with an incorrect bit rate target as if they were ARF overlay frames.
The second issue relates to the encoding of a single short GF group
just before a key frame. Where the last group before a key frame
is an ARF group we expect the final frame before the key frame to
be an low data rate overlay frame. However, when the last group
is a GF group, the final frame before the key frame should be a normal
frame with a normal bit allocation. This issue had the potential to cause
a single poorly coded frame just before a key frame. If that key frame
were a forced key frame rather than a real scene cut, this might cause
pulsing.
Change-Id: Idf1eb5eaf63a231495a74de7899236e1ead9fb00
Testing on another rate control patch reveals that in some
situations, where the encoder is flipping in and out of arf
mode, we get an encoder decoder mismatch.
Whilst it is still not clear why, skipping the last buffer
update seems to trigger the problem. Until I can establish
why, or if there is another underlying cause, I am reverting
this change.
This reverts commit e5112b3ae3352c4c55fb31235305f3f80f4b8f7e.
Change-Id: I315c5200414de89458015823344b7367e9dd75ba
With the sad functions, and hopefully the variance functions soon,
moving to the vpx_dsp location, place the defines used in the
reference C code in a common location.
Change-Id: I4c8ce7778eb38a0a3ee674d2f1c488eda01cfeca
The computation of new metrics is not supported yet in highbitdepth
mode. This commit adds protection to make sure the computation is
done only when highbitdepth is not on. This protection shall be
revised when support of highbitdpeth computation is added.
This resolves the encoder crash when configured with both
--enable-internal-stats
--enable-vp9-highbitdepth
Change-Id: Id9f4bcc4fa26d9ca0e9eabade83f3f88a5b212e6
Where a frame appears to be a repeat of an earlier
frame or frame buffer, but the first pass code
does not anticipate this (usually because it is matching
the GF or ARF buffer not the last frame buffer), do not
update the last frame buffer.
This helps ensure that the content of the last frame buffer
is kept "different" where possible, and not updated to
match the GF or ARF. This is particularly helpful in some
animated sequences where there are groups of repeating
frames. Here it has quite a big impact. However, in most
of our standard test clips it has little or no impact.
Change-Id: I77332ee1a69f9ffc0c6080bfeb811c43fd8828e6
Create a new component, vpx_dsp, for code that can be shared
between codecs. Move the SAD code into the component.
This reduces the size of vpxenc/dec by 36k on x86_64 builds.
Change-Id: I73f837ddaecac6b350bf757af0cfe19c4ab9327a
(see I3a05cf1610679fed26e0b2eadd315a9ae91afdd6)
For the test clip used, the decoder performance improved by ~2%.
This is also an intermediate step towards adding back the
mode_info streams.
Change-Id: Idddc4a3f46e4180fbebddc156c4bbf177d5c2e0d
PSNR HVS is a human visual system weighted version of SNR that's
gained some popularity from academia and apparently better matches
MOS testing.
This code is borrowed from the Daala Project but uses our FDCT code.
Change-Id: Idd10fbc93129f7f4734946f6009f87d0f44cd2d7
The vbp thresholds are set seperately for boosted/non-boosted
superblocks according to their segment_id. This way we don't
have to force the boosted blocks to split to 32x32.
Speed 6 RTC set borg test result showed some quality gains.
Overall PSNR: +0.199%; Avg PSNR: +0.245%; SSIM: +0.802%.
No speed change was observed.
Change-Id: I37c6643a3e2da59c4b7dc10ebe05abc8abf4026a
For non-SVC 1 pass CBR: make the GF update interval a multiple of the
cyclic refresh period, and use encoding stats to prevent GF update at certain times.
Change-Id: I4c44cacc2f70f1d27391a47644837e1eaa065017
Frame buffers are now allocated dynamically on-demand.
Entries in the reference frame map, cm->ref_frame_map,
may now be set to -1 (INVALID_IDX) to indicate that
there is not a valid reference buffer in that "slot".
All slots in the reference frame map are now initialized
to the empty state (-1) and each buffer is initialized
to have a reference count of 0.
Change-Id: Id1afe98de98db4ae8b2dfefed7889c3b28c68582
Simple skin detection, from vp8; works reasonable on most of the
RTC clips, but could miss sometimes.
Added debug flag to write out skin map over source input.
Change-Id: I2caea7592f1c459047aac46627eeb24a94946464
This is to avoid redo the same calculation repeatly, and also allow
easier adjustments for further experiments.
This commit shall have no effect on quality/compression.
Change-Id: I4460acf5c808ff5518da18d21e002c5da58af857
Note: This feature is still in development.
Add an option for the encoder to decide the resolution
at which to encode each frame.
Each KF/GF/ARF goup is tested to see if it would be
better encoded at a lower resolution. At present, each
KF/GF/ARF is coded first at full-size and if the coded
size exceeds a threshold (twice target data rate) at
the maximum active Q then the entire group is encoded
at lower resolution.
This feature is enabled in vpxenc by setting:
--resize-allowed=1
In addition, if the vpxenc command line also specifies
valid frame dimensions using:
--resize-width=XXXX & --resize_height=YYYY
then *all* frames will be encoded at this resolution.
Change-Id: I13f341e0a82512f9e84e144e0f3b5aed8a65402b
In frame parallel decode, libvpx decoder decodes several frames on all
cpus in parallel fashion. If not being flushed, it will only return frame
when all the cpus are busy. If getting flushed, it will return all the
frames in the decoder. Compare with current serial decode mode in which
libvpx decoder is idle between decode calls, libvpx decoder is busy
between decode calls.
Current frame parallel decode will only speed up the decoding for frame
parallel encoded videos. For non frame parallel encoded videos, frame
parallel decode is slower than serial decode due to lack of loopfilter
worker thread.
There are still some known issues that need to be addressed. For example:
decode frame parallel videos with segmentation enabled is not right sometimes.
* frame-parallel:
Add error handling for frame parallel decode and unit test for that.
Fix a bug in frame parallel decode and add a unit test for that.
Add two test vectors to test frame parallel decode.
Add key frame seeking to webmdec and webm_video_source.
Implement frame parallel decode for VP9.
Increase the thread test range to cover 5, 6, 7, 8 threads.
Fix a bug in adding frame parallel unit test.
Add VP9 frame-parallel unit test.
Manually pick "Make the api behavior conform to api spec." from master branch.
Move vp9_dec_build_inter_predictors_* to decoder folder.
Add segmentation map array for current and last frame segmentation.
Include the right header for VP9 worker thread.
Move vp9_thread.* to common.
ctrl_get_reference does not need user_priv.
Seperate the frame buffers from VP9 encoder/decoder structure.
Revert "Revert "Revert "Revert 3 patches from Hangyu to get Chrome to build:"""
Conflicts:
test/codec_factory.h
test/decode_test_driver.cc
test/decode_test_driver.h
test/invalid_file_test.cc
test/test-data.sha1
test/test.mk
test/test_vectors.cc
vp8/vp8_dx_iface.c
vp9/common/vp9_alloccommon.c
vp9/common/vp9_entropymode.c
vp9/common/vp9_loopfilter_thread.c
vp9/common/vp9_loopfilter_thread.h
vp9/common/vp9_mvref_common.c
vp9/common/vp9_onyxc_int.h
vp9/common/vp9_reconinter.c
vp9/decoder/vp9_decodeframe.c
vp9/decoder/vp9_decodeframe.h
vp9/decoder/vp9_decodemv.c
vp9/decoder/vp9_decoder.c
vp9/decoder/vp9_decoder.h
vp9/encoder/vp9_encoder.c
vp9/encoder/vp9_pickmode.c
vp9/encoder/vp9_rdopt.c
vp9/vp9_cx_iface.c
vp9/vp9_dx_iface.c
This reverts commit a18da9760a74d9ce6fb9f875706dc639c95402f5.
Change-Id: I361442ffec1586d036ea2e0ee97ce4f077585f02
