certain mix of calls to RC4 routine not covered by rc4test.c.
It's fixed now. In addition this patch inadvertently fixes minor
performance problem: in 0.9.7 context P4 was performing 12% slower
than the original implementation...
check_ca(), to resolve constness issue. check_ca() is called from the
purpose checkers instead of X509_check_ca(), since the stuff done by
the latter (except for calling check_ca()) is also done by
X509_check_purpose().
check_ca(), to resolve constness issue. check_ca() is called from the
purpose checkers instead of X509_check_ca(), since the stuff done by
the latter (except for calling check_ca()) is also done by
X509_check_purpose().
CA setting in each certificate on the chain is correct. As a side-
effect always do the following basic checks on extensions, not just
when there's an associated purpose to the check:
- if there is an unhandled critical extension (unless the user has
chosen to ignore this fault)
- if the path length has been exceeded (if one is set at all)
- that certain extensions fit the associated purpose (if one has been
given)
CA setting in each certificate on the chain is correct. As a side-
effect always do the following basic checks on extensions, not just
when there's an associated purpose to the check:
- if there is an unhandled critical extension (unless the user has
chosen to ignore this fault)
- if the path length has been exceeded (if one is set at all)
- that certain extensions fit the associated purpose (if one has been
given)
apparently impossible to compose blended code with would perform
satisfactory on all x86 and x86_64 cores, an extra RC4_CHAR
code-path is introduced and P4 core is detected at run-time. This
way we keep original performance on non-P4 implementations and
turbo-charge P4 performance by factor of 2.8x (on 32-bit core).
guys had to change the name to differentiate with older versions when
a backward incompatibility came up. Of course, we need to adapt.
This change simply tries to load the library through the newer name
(ZLIB1) first, and if that fails, it tries the good old ZLIB.
guys had to change the name to differentiate with older versions when
a backward incompatibility came up. Of course, we need to adapt.
This change simply tries to load the library through the newer name
(ZLIB1) first, and if that fails, it tries the good old ZLIB.
