At lower bitrates, it is overall faster to conditionally do one block
at a time with SSE2 on Haswell and likely other common architectures.
At higher bitrates, it is faster to use the wider routine that IDCTs
four blocks at a time. To avoid potential performance regressions
as compared to MMX, stick with single-block IDCTs with SSE2. There
is still a performance advantage as compared to MMX because the
single-block SSE2 routine is faster than the corresponding MMX
routine.
Stick with four blocks at a time with AVX2 for which that appears
to be consistently faster on Haswell.
Move asm routines to common. Delete obsolete decoder routines.
Use wider routines where applicable.
~1.07x overall faster decode on a quick 720p30 4Mbps test on Haswell.
WelsSampleSatd16x16_avx2 (~2.31x speedup over SSE4.1 on Haswell).
WelsSampleSatd16x8_avx2 (~2.19x speedup over SSE4.1 on Haswell).
WelsSampleSatd8x16_avx2 (~1.68x speedup over SSE4.1 on Haswell).
WelsSampleSatd8x8_avx2 (~1.53x speedup over SSE4.1 on Haswell).
In 9cb4f4e8e2, the error code returned from CheckIntraNxNPredMode
was changed - therefore, these return value checks, that look
for a specific error code, need to be updated accordingly.
This fixes crashes in DecodeCrashTestAPI.DecoderCrashTest
with some seeds.
Prior to 7bcb3ba4f4,
pCurLayer->sLayerInfo.pSliceInLayer[uiSliceIdx].iCountMbNumInSlice
was read after setting pCurLayer->sLayerInfo.pSliceInLayer to
the newly allocated, larger array. After this commit, it is read
before the array has been switched, and thus is read from the
old array (which only holds elements up to iMaxSliceNumOld, not
up to iMaxSliceNum).
This fixes reads out of bounds, and crashes in the test suite.
The "Video signal type present" information is written to the output
video file when it is created, and later is used by the decoder to
properly decode the compressed video data. The saved attributes
are:
- format type (PAL, NTSC, etc.)
- color primaries (BT709, SMPTE170M, etc.)
- transfer characteristics (BT709, SMPTE170M, etc.)
- color matrix ((BT709, SMPTE170M, etc.)
These modifications allow the client to specify these attributes
and, if specified, makes sure they are written to the output file.
The "Video signal type present" information is written to the output
video file when it is created, and later is used by the decoder to
properly decode the compressed video data. The saved attributes
are:
- format type (PAL, NTSC, etc.)
- color primaries (BT709, SMPTE170M, etc.)
- transfer characteristics (BT709, SMPTE170M, etc.)
- color matrix ((BT709, SMPTE170M, etc.)
These modifications allow the client to specify these attributes
and, if specified, makes sure they are written to the output file.
