This patch is meant to prevent users from running out of memory
when using 0MQ in the default configuration.
Signed-off-by: Martin Sustrik <sustrik@250bpm.com>
At this point option exists, is documented and can be set,
however, it has no effect.
Signed-off-by: Steven McCoy <steven.mccoy@miru.hk>
Signed-off-by: Martin Sustrik <sustrik@250bpm.com>
The filtering is now done depending on the socket type. SUB socket
filters the messages (end-to-end filtering) while XSUB relies
on upstream nodes to do (imprefect) filtering.
Signed-off-by: Martin Sustrik <sustrik@250bpm.com>
So far there was no distinction between message parts used by 0MQ
and message parts used by user. Now, the message parts used by 0MQ
are marked as 'LABEL'.
Signed-off-by: Martin Sustrik <sustrik@250bpm.com>
This option is a performance tweak. In devices XSUB socket filters
the messages just to send them to XPUB socket which filters them
once more. Setting ZMQ_FILTER option to 0 allows to switch the
filtering in XSUB socket off.
Signed-off-by: Martin Sustrik <sustrik@250bpm.com>
These new options allow to control the maximum size of the
inbound and outbound message pipe separately.
Signed-off-by: Martin Sustrik <sustrik@250bpm.com>
On-disk storage should be implemented in devices rather than
in 0MQ core. 0MQ is a networking library and there's no point
in storing network buffers on disk.
Signed-off-by: Martin Sustrik <sustrik@250bpm.com>
Multicast loopback is not a real multicast, rather a kernel-space
simulation. Moreover, it tends to be rather unreliable and lossy.
Removing the option will force users to use transports better
suited for the job, such as inproc or ipc.
Signed-off-by: Martin Sustrik <sustrik@250bpm.com>
The new option allows user to guard against peers sending
oversized messages. Connection to peer sending oversized message
is dropped.
Signed-off-by: Martin Sustrik <sustrik@250bpm.com>
For very high-speed message systems, the memory used for recovery can get to
be very large. The corrent limitation on that reduction is the ZMQ_RECOVERY_IVL
of 1 sec. I added in an additional option ZMQ_RECOVERY_IVL_MSEC, which is the
Recovery Interval in milliseconds. If used, this will override the previous
one, and allow you to set a sub-second recovery interval. If not set, the
default behavior is to use ZMQ_RECOVERY_IVL.
Signed-off-by: Bob Beaty <rbeaty@peak6.com>
- Clarify ZMQ_LINGER, zmq_close (), zmq_term () relationship
- New socket options
- Clarify thread safety of sockets and migration between threads
- Other minor and spelling fixes
Signed-off-by: Martin Lucina <mato@kotelna.sk>
1. ZMQ_LINGER option can be set/get
2. options are part of own_t base class rather than being declared
separately by individual objects
3. Linger option is propagated with "term" command so that the
newest value of it is used rather than the stored old one.
4. Session sets the linger timer if needed and terminates
as soon as it expires.
5. Corresponding documentation updated.
Signed-off-by: Martin Sustrik <sustrik@250bpm.com>
- fixed unwrapped text in new man pages
- fixed over-long lines in older pages, where possible
- removed reference to old standalong devices from index page
- added refernce to new zmq_device[3] documented from index page
- some minor spelling corrections
