The Apple HTTP Live Streaming demuxer's implementation of
seeking searches for the MPEG TS segment which contains the
requested timestamp. In its current implementation it assumes
that the first segment will start from 0.
But, MPEG TS streams do not necessarily start with timestamp
(near) 0, causing seeking to fail for those streams.
This also occurs when using live streaming of HTTP Live Streams.
In this case sliding playlists may be used, which means that in
that case only the last x encoded segments are stored, the earlier
segments get deleted from disk and removed from the playlist.
Because of this, when starting playback of a stream in the middle
of such a broadcast, the initial segment fetched after parsing
the m3u8 playlist will not start from timestamp (near) 0, causing
(the admittedly limited live) seeking to fail.
This patch changes this demuxers seeking implementation to use
the initial DTS as an offset for searching the segments containing
the requested timestamp.
Signed-off-by: Martin Storsjö <martin@martin.st>
The tls protocol handles connections via proxies internally.
With TLS/SSL, the peer verification requires that the client
speaks directly with the server, since the proxy doesn't have
the remote server's private key.
Signed-off-by: Martin Storsjö <martin@martin.st>
This opens a plain TCP connection through the proxy via the
CONNECT HTTP method. Normally, this is allowed for connections
on port 443, but can in general be used to allow connections
to any port (depending on proxy configuration), and could thus
be used to tunnel any TCP connection via a HTTP proxy.
Signed-off-by: Martin Storsjö <martin@martin.st>
RTCP timestamps are only necessary to synchronize time between
multiple streams. For a single stream, the RTP packet timestamp
provides more reliable timing. As a result, single-stream RTP
sessions should now have accurate and monotonic PTS.
Signed-off-by: Martin Storsjö <martin@martin.st>
Note: Some of the previous patches have had two bugs that have been fixed
in this patch.
Signed-off-by: Michael Bradshaw <mbradshaw@sorensonmedia.com>
Signed-off-by: Michael Niedermayer <michaelni@gmx.at>
Our ac3 code chain can handle it fine.
More ideal would be to write a demuxer that actually extracts what can be from the additional
headers and uses it for whatever it can be used for.
Signed-off-by: Michael Niedermayer <michaelni@gmx.at>
TLSv1 is compatible with SSLv3, so this doesn't change much
in terms of compatibility. By explicitly using TLSv1, OpenSSL
sends the server name indication (SNI) header, which we
already set using SSL_set_tlsext_host_name (earlier, this
didn't have any effect).
SNI allows servers to serve SSL content for different host
names with separate certificates on one single port (vhosts).
Signed-off-by: Martin Storsjö <martin@martin.st>
