A separate rtcp port can already be set when opening the rtp
protocol normally, but when doing port setup as in RTSP (where
we first need to open the local ports and pass them to the peer,
and only then receive the remote peer port numbers), we didn't
check the same url parameter as in the normal open routine.
Signed-off-by: Martin Storsjö <martin@martin.st>
I doubt that anyone ever would try to send a 1 byte packet
via the RTP protocol, but check just in case - it shouldn't
crash at least.
Signed-off-by: Martin Storsjö <martin@martin.st>
AVIOContext has got an av_class member that only gets set if
opening the context using avio_open2, but not if allocating a
custom IO context. A caller that wants to read AVOptions from
an AVIOContext (recursively using AV_OPT_SEARCH_CHILDREN) may
not know if the AVIOContext actually has got a class set or not.
Signed-off-by: Martin Storsjö <martin@martin.st>
This allows the chained demuxer (or more precisely, the lavf
utility code) to better fill in timestamps on packets from
these, especially for cases where one stream is a raw ADTS
stream.
Signed-off-by: Martin Storsjö <martin@martin.st>
Add support for domain names, for multiple source addresses,
for exclusions, and for session level specification of addresses.
Signed-off-by: Martin Storsjö <martin@martin.st>
This allows us to explicitly fail if the caller tried to set
both inclusions and exclusions at the same time.
Signed-off-by: Martin Storsjö <martin@martin.st>
Previously this only allowed literal IP addresses. When these
are conveyed in a SDP file as in RFC4570, host names are allowed
as well.
Signed-off-by: Martin Storsjö <martin@martin.st>
Also parse segment durations as floating point, which is allowed
since HLS version 3.
This is based on a patch by Zhang Rui.
Signed-off-by: Martin Storsjö <martin@martin.st>
When first_timestamp was stored as-is, its actual time base
wasn't known later in the seek function.
Additionally, the logic (from 795d9594cfa) for scaling it
based on stream_index is flawed - stream_index in the seek
function only specifies which stream the seek timestamp refers
to, but obviously doesn't say anything about which stream
first_timestamp belongs to.
In the cases where stream_index was >= 0 and all streams had the
same time base, this didn't matter in practice.
Seeking taking first_timestamp into account is problematic
when one variant is mpegts (with real timestamps) and one variant
is raw ADTS (with timestamps only being accumulated packet
duration), where the variants start at totally different timestamps.
Signed-off-by: Martin Storsjö <martin@martin.st>
