an app can use to let libcurl only connect to a remote host and then extract
the socket from libcurl. libcurl will then not attempt to do any transfer at
all after the connect is done.
even after EPSV returned a positive response code, if libcurl failed to
connect to the port number the EPSV response said. Obviously some people are
going through protocol-sensitive firewalls (or similar) that don't understand
EPSV and then they don't allow the second connection unless PASV was
used. This also called for a minor fix of test case 238.
(CURLOPT_FTPPORT) didn't work for ipv6-enabed curls if the IP wasn't a
"native" IP while it works fine for ipv6-disabled builds!
In the process of fixing this, I removed the support for LPRT since I can't
think of many reasons to keep doing it and asking on the mailing list didn't
reveal anyone else that could either. The code that sends EPRT and PORT is
now also a lot simpler than before (IMHO).
given subdirs, libcurl would still "remember" the full path as if it is the
current directory libcurl is in so that the next curl_easy_perform() would
get really confused if it tried the same path again - as it would not issue
any CWD commands at all, assuming it is already in the "proper" dir.
Starting now, a failed CWD command sets a flag that prevents the path to be
"remembered" after returning.
that made curl run fine in his end. The key was to make sure we do the
SSL/TLS negotiation immediately after the TCP connect is done and not after
a few other commands have been sent like we did previously. I don't consider
this change necessary to obey the standards, I think this server is pickier
than what the specs allow it to be, but I can't see how this modified
libcurl code can add any problems to those who are interpreting the
standards more liberally.
fix the CONNECT authentication code with multi-pass auth methods (such as
NTLM) as it didn't previously properly ignore response-bodies - in fact it
stopped reading after all response headers had been received. This could
lead to libcurl sending the next request and reading the body from the first
request as response to the second request. (I also renamed the function,
which wasn't strictly necessary but...)
The best fix would to once and for all make the CONNECT code use the
ordinary request sending/receiving code, treating it as any ordinary request
instead of the special-purpose function we have now. It should make it
better for multi-interface too. And possibly lead to less code...
Added test case 265 for this. It doesn't work as a _really_ good test case
since the test proxy is too stupid, but the test case helps when running the
debugger to verify.
internally, with code provided by sslgen.c. All SSL-layer-specific code is
then written in ssluse.c (for OpenSSL) and gtls.c (for GnuTLS).
As far as possible, internals should not need to know what SSL layer that is
in use. Building with GnuTLS currently makes two test cases fail.
TODO.gnutls contains a few known outstanding issues for the GnuTLS support.
GnuTLS support is enabled with configure --with-gnutls
file got a Last-Modified: header written to the data stream, corrupting the
actual data. This was because some conditions from the previous FTP code was
not properly brought into the new FTP code. I fixed and I added test case 520
to verify. (This bug was introduced in 7.13.1)
on the remote side. This then converts the operation to an ordinary STOR
upload. This was requested/pointed out by Ignacio Vazquez-Abrams.
It also proved (and I fixed) a bug in the newly rewritten ftp code (and
present in the 7.13.1 release) when trying to resume an upload and the servers
returns an error to the SIZE command. libcurl then loops and sends SIZE
commands infinitely.
